Tire & auto shop
Services
New and used tires, brakes, A/C and engine work — foreign and domestic. You hear the price before we touch the vehicle, and most of it goes out the same day.
-
Tires & wheels
New and used tires, custom wheels, mounting and balancing.
Typically includes
- Mount and computer balance
- New valve stems or TPMS service kit
- Torque to factory spec
- Old tire disposal
- Pressure set and road test
-
Brakes & safety
Pads, rotors, calipers and full brake inspections.
Typically includes
- Pads and rotors, front or rear
- Hardware, shims and clips
- Caliper slides cleaned and lubricated
- Brake fluid level and condition check
- Road test and bed-in
-
Engine & performance
Diagnostics through engine work, foreign and domestic.
Typically includes
- Diagnosis before any teardown
- Gaskets, seals and hardware replaced
- Fluids refilled to spec
- Post-repair scan and road test
-
Oil & fluid service
Conventional through full synthetic, filters and fluids.
Typically includes
- Oil and filter, spec grade
- Drain plug gasket replaced
- All fluids topped off
- Tire pressures set
- Used oil disposal
-
A/C & heating
Recharge, leak diagnosis and component replacement.
Typically includes
- Performance test, vent temperature measured
- Leak check with dye or electronic detector
- System evacuated and recharged
- Refrigerant oil and dryer as needed
-
Cooling system
Radiators, water pumps, thermostats and hoses.
Typically includes
- Coolant drain and flush
- System pressure and cap test
- Thermostat, hoses and clamps as needed
- Bleed and heat-cycle check
-
Transmission
Service, diagnosis and replacement.
Typically includes
- Fluid and filter service
- Pan gasket replaced
- Scan for transmission codes
- Level set at operating temperature
-
Suspension & steering
Struts, shocks, control arms and alignments.
Typically includes
- Struts, shocks, control arms or tie rods
- Mounts, bearings and boots
- Torque to spec at ride height
- Alignment recommendation after install
-
Exhaust & emissions
Exhaust repair and emissions troubleshooting.
Typically includes
- Leak inspection, manifold to tip
- Gaskets, clamps and hangers
- Oxygen sensor testing
- Emissions readiness verified
-
Electrical & starting
Batteries, starters, alternators and wiring faults.
Typically includes
- Battery load and charging system test
- Starter draw test
- Terminals cleaned, cables checked
- Alternator output under load
-
Diagnostics & inspection
Check-engine scans and pre-trip inspections.
Typically includes
- Full OBD scan, stored and pending codes
- Live data under load
- Visual inspection of the affected system
- Written findings before work is quoted
-
Trucks & off-road
Lift kits, oversized tires and truck-specific work.
Typically includes
- Lift kits and leveling components
- Oversized tire fitment confirmed
- Torque to spec at ride height
- Alignment recommendation after install
Not sure what you need?
Call and describe what the vehicle is doing. We'll tell you what it likely needs before we come out.