The shop your neighbor told you about.

• Tires & wheels

  New and used tires, custom wheels, mounting and balancing.

  Typically includes

  • Mount and computer balance
  • New valve stems or TPMS service kit
  • Torque to factory spec
  • Old tire disposal
  • Pressure set and road test

• Brakes & safety

  Pads, rotors, calipers and full brake inspections.

  Typically includes

  • Pads and rotors, front or rear
  • Hardware, shims and clips
  • Caliper slides cleaned and lubricated
  • Brake fluid level and condition check
  • Road test and bed-in

• Engine & performance

  Diagnostics through engine work, foreign and domestic.

  Typically includes

  • Diagnosis before any teardown
  • Gaskets, seals and hardware replaced
  • Fluids refilled to spec
  • Post-repair scan and road test

• Oil & fluid service

  Conventional through full synthetic, filters and fluids.

  Typically includes

  • Oil and filter, spec grade
  • Drain plug gasket replaced
  • All fluids topped off
  • Tire pressures set
  • Used oil disposal

• A/C & heating

  Recharge, leak diagnosis and component replacement.

  Typically includes

  • Performance test, vent temperature measured
  • Leak check with dye or electronic detector
  • System evacuated and recharged
  • Refrigerant oil and dryer as needed

• Cooling system

  Radiators, water pumps, thermostats and hoses.

  Typically includes

  • Coolant drain and flush
  • System pressure and cap test
  • Thermostat, hoses and clamps as needed
  • Bleed and heat-cycle check

• Transmission

  Service, diagnosis and replacement.

  Typically includes

  • Fluid and filter service
  • Pan gasket replaced
  • Scan for transmission codes
  • Level set at operating temperature

• Suspension & steering

  Struts, shocks, control arms and alignments.

  Typically includes

  • Struts, shocks, control arms or tie rods
  • Mounts, bearings and boots
  • Torque to spec at ride height
  • Alignment recommendation after install

• Exhaust & emissions

  Exhaust repair and emissions troubleshooting.

  Typically includes

  • Leak inspection, manifold to tip
  • Gaskets, clamps and hangers
  • Oxygen sensor testing
  • Emissions readiness verified

• Electrical & starting

  Batteries, starters, alternators and wiring faults.

  Typically includes

  • Battery load and charging system test
  • Starter draw test
  • Terminals cleaned, cables checked
  • Alternator output under load

• Diagnostics & inspection

  Check-engine scans and pre-trip inspections.

  Typically includes

  • Full OBD scan, stored and pending codes
  • Live data under load
  • Visual inspection of the affected system
  • Written findings before work is quoted

• Trucks & off-road

  Lift kits, oversized tires and truck-specific work.

  Typically includes

  • Lift kits and leveling components
  • Oversized tire fitment confirmed
  • Torque to spec at ride height
  • Alignment recommendation after install

Full service list